To test this you ll need to open up the washer and locate the control panel.
Maytag washer not filling up with water.
No valve blockage and electric valves open and close when bench tested.
Before proceeding you have to make sure that the washer is unplugged in order to eliminate the risk of electric shock.
If water is getting to the washer but will not fill with water then check the water inlet fill valve where the water supply hoses screw onto the washer.
The water inlet valve requires sufficient water pressure to function properly.
Maytag washer mvwb765w.
Learn about the reasons why your washer won t fill with water.
You may notice during a cycle that the wash load is not completely submerged in water.
There may be a bad wire connection on the water inlet valve or a bad solenoid valve that is not letting water into your washing machine rr.
If your washer continues to fill during a cycle the water inlet valve could be at fault.
Your high efficiency he top loading washer with an impeller instead of an agitator is not designed to fill up with water except in the rinse cycle when extra rinse is selected or when the fabric softener option is selected.
Control board was tested and it too is not the problem.
Your washer senses the load size and composition through a series of fills and wash motions.
Fixing the washing machine is simple with our diy repair help and videos.
A maytag top load washer fails to fill with water for a variety of reasons including closed water valves kinked hoses and dirty valve screens according to the manufacturer.
If so make sure the water supply hoses are not bent.
Will not fill with water.
If your washer if not filling start by making sure the faucet at the water supply end of the hose is turned on.
They re about four or five feet long and attach to the back of the machine at the water inlet valve.
If the washer continues to fill then the water inlet valve is defective.
Next inspect your hoses for crimps or kinks.
To verify that the valve is at fault unplug the washer when the symptom occurs.
The water inlet valve opens to allow water to enter the washing machine.
The washer senses the size of the load and adds the correct amount of water for the load size.
Find information on common parts that may be worn out or broken like the water inlet valve the lid switch and the selector switch.
If the water level seems too low or if the washer does not fill completely auto sensing helps stabilize the amount of water used.
The reason the washing machine won t fill might lie with the water level switch.
If the water inlet valve is defective the wash may fill slowly or not fill at all.
01 water inlet valve.
If the washer stops filling then the problem is related to the electrical circuit that controls the.
