Choose the highest spin speed for that particular material.
Maytag washer spin cycle not working.
Timer the timer supplies power to turn the motor.
Tighten or replace the belt.
Verify that the switch is being activated mechanically and that any levers or actuators are not damaged or sticking.
If the timer is defective the motor will not turn therefore no washer agitation.
1 check the washing machine s spin cycle.
If you choose the no spin or low spin option your maytag washer might not remove all of the water from your clothes.
If the spin cycle works the motor is operating and the belt is not broken.
If the spin cycle doesn t work the belt may be loose or broken.
As it spins it will simultaneously throw water out of the appliance through the drain hose which empties into a sink or drain pipe.
Although the process is fairly simple there are a number of problems that may occur.
If the lid switch does not have continuity replace it.
If the lid switch fails the washer may not spin.
If the lid switch assembly fails the washer will not spin.
Lid switch the lid switch makes it so if the lid is opened the machine will not run.
The slow spin could be caused by the brake not releasing properly bearings or a worn thrust bearing.
When the drive pulley rotates counterclockwise.
Look at the dial selection to make sure you have selected the proper spin speed for the material you are washing.
The lid switch assembly prevents the washer from spinning when the lid is open.
Washing machine settings explained the normal cycle is a go to for day to day loads.
Maytag bravos washer will not continue to the next cycle after the wash cycle.
If it goes bad the machine will not agitate.
This specific maytag model should be serviced by a technician with the experience knowledge and tools to properly diagnose and repair this symptom.
If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch.
If the machine starts spinning normally simply re bend the.
The lid switch is normally located beneath the main top with a projection on the lid or a pin attached to the lid that will actuate the switch when the lid is closed.
In theory when your maytag washer reaches its spin cycle it should begin spinning.
A bad lid switch will make it so power cannot get to the drive motor.
