The mechanic informed me that it is because of a leak in the brake.
Mazda 3 brake pedal goes to floor.
I tried stopping a few more times and no matter what i did the pedal went to the floor and the abs came on every single time.
Items 3 4 and 5 are reasons why the pedal could sink to the floor with no leak at all.
If this bearing goes bad it will allow the brake rotor it move back and fourth which pushes the caliper piston back into the caliper creating an air gap.
The brake pedal started going halfway to the floor before the brakes engage although braking action seems normal after that maybe a little soft pedal.
A brake fluid leak is.
My mazda 3 2008 model was noticed to have an air leak when you press the brake pedal heavily or suddenly.
We replaced the brake master cylinder but the pedal is still soft goes a little bit down that the usual but stops say an inch before it hits the floor.
2005 mazda 3 2 3l 5 speed.
The pedal still goes to the floor.
Axle bearings hold the brake rotor true without play while they both rotate.
Below we have listed five common reasons why your mazda 3 s brake pedal may be hitting the floor.
I ve got a 2008 mazda 3i with 120k miles on it manual transmission.
Tried turning the car off and back on same problem.
The repair guy took it to a ride with me we hit the brake in a parking lot on high speeds low speeds everything it always stops properly no problem there.
A strange hissing noise coming from the pedal area.
A possible loss of power assist making the brakes really hard to push at times.
Brake fluid level looks good no dash lights are on.
3 brake pedal goes to floor.
I suspect the master cylinder is going bad but could it be anything else.
A sudden loss of braking ability with super spongy pedals.
But i found that a.
Cx 9 owners especially those in hotter climates have been telling harrowing tales of brake problems centered around.
The abs came on again.
Brake pedal goes to the floor just replaced for the second time in 2yrs the master cylinder.
Items 1 and 2 are what you want to look at if there is a brake leak.
So at the next stop sign i went to push on the brake pedal but it pretty much went to the floor.
The brakes are working totally fine.